2007-02-20
Bass Gear For Sale
Ampeg B-1 Combo - $300
The B-1 Combo is a 150 Watt amplifier mounted into a 4 Ohms cabinet with 1x12" speaker and 1x4" horn. The horn has an attenuator at 0dB, -6dB and -10dB. The preamp is tube driven with brand new Ruby 12AX7 tubes. Additional features are a limiter and a footswitchable "Solo" channel. The footswitch is not included.
This amp is used. There are some places where the tolex is work through to the wood below. The Boost knob is also missing, though the control still works just fine.
Controls
- Front Panel (left to right)
- Input
- Peak LED
- Gain
- Ultra Low
- 15dB Pad
- Bass (Pull Shift - lowers center frequency)
- Midrange
- Treble (Pull Shift - raises center frequency)
- Ultra High
- Balance Out Pre/Post EQ Switch
- Solo Channel Voice (knob is missing, control works)
- Solo Channel Boost
- Solo Channel Active LED
- Limiter Enable
- Solo Channel Enable
- Limit LED
- Master Volume
- Power LED
- Power Switch
- Rear Panel
- AC Line In (120V IEC Cable)
- Two (2) Speaker Outputs - 150 Watts at 4 Ohms
- Power Amp In
- Preamp Out
- Effects Loop Return
- Effects Loop Send
- Balanced Out (D.I.)
- Footswitch
- Speaker Cabinet
- High Frequency Horn Attenuator (-10dB, -6dB, 0dB)
- Normal Input
- Contour Input (scooped midrange)
Ampeg SVT-1510HE Speaker Cabinet - $250
The SVT-1510HE is an 8 Ohms speaker cabinet with 1x15" speaker, 1x10" speaker and 1x4" horn. The Cabinet is rated at 175W. The high frequency horn has an attenuator for OFF, -6dB and 0dB. There are two parallel inputs. The original 10" speaker was replaced with an Eminence Delta 10B rated at 350 Watts, much over the stock 80 Watt rated speaker. This cabinet will match up with other "Classic" series Ampeg products. The casters align with the insets on the cabinets for stacking and the rubber feet on the heads (SVT-CL, SVT-350H, V4B) line up with the insets.
This cabinet is used. There are some scuffs and wear. The tolex covering has become loose on one side near the bottom.
Subscribe to Posts [Atom]
